|
Never exceed the Work Load Limit. The Work Load Limit is the maximum load
which should ever be applied to the product, even when
the product is new and when the load is uniformly applied
— straight line pull only. Avoid side loading. All
catalog listings are based upon usual environmental
conditions, and consideration must be given to unusual
conditions such as extreme high or low temperatures,
chemical solutions or vapors, prolonged immersion in
salt water, etc. Such conditions or high risk applications
may necessitate reducing the work load limit. Work Load
Limit will not apply if product has been welded or otherwise
been modified.
Match components properly. Make certain that components such as hooks,
links or shackles, etc. used with wire rope (or chain
or cordage) are of suitable material and strength to
provide adequate safety protection. Attachments must
be properly installed and must have a Work Load Limit
at least equal to the product with which they are used.
Keep out from under a raised load. Conduct all lifting operations in such
a manner, that if there were an equipment failure, no
personnel would be injured. This means keep out from
under a raised load and keep out of the line of force
of any load.
Avoid shock loads. Avoid impacting, jerking or swinging of
load — Work Load Limit will not apply. A shock load
is generally significantly greater than the static load.
Inspect product regularly. No product can keep operating at its rated
capacity indefinitely. Periodic inspections help determine
when to replace a product and reduce rigging hazards.
Check for visible damage, cracks, wear, elongation,
rust, etc. When in doubt about the extent of the damage,
retire the item in question immediately.
Destroy, rather than discard, items that have been judged
defective. They might be used again by someone not
aware of the hazard of the defect. |
Important Warnings and Information